Synaccess Networks NP-0801DTM - Manual (Page 214)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 214
#SS: 2,4,91.80.90.162,1000
#SS: 3,0
#SS: 4,0
#SS: 5,3,91.80.73.70,61120,88.37.127.146,10509
#SS: 6,0
OK
Socket 1: opened from local IP 91.80.90.162/local port 61119 to remote IP 88.37.127.146/remote port 10510 is
suspended with pending data
Socket 2: listening on local IP 91.80.90.162/local port 1000
Socket 5: opened from local IP 91.80.73.70/local port 61120 to remote IP 88.37.127.146/remote port 10509 is
suspended with pending data
AT#SS=2
#SS: 2,4,91.80.90.162,1000
OK
Information only about socket number 2
Socket Info #SI
Execute command gets information about socket data traffic.
Test command reports the range for parameter .
Syntax
Command Command type
AT#SI[=] Execute
AT#SI=?s Test
Parameters and Values
Socket connection identifier.
1‐6
The response format is:
#SI: ,,,,
where:
Socket connection identifier.
Total amount (in bytes) of sent data since the last time the socket connection
identified by is opened.
Total amount (in bytes) of received data since the last time the socket connection
identified by is opened.
Total amount (in bytes) of data just arrived through the socket connection
identified by and currently buffered, not yet read.
Total amount (in bytes) of sent and not yet acknowledged data since the last time