Synaccess Networks NP-0801DTM - Manual (Page 107)

3GPP TS 27.007 AT COMMANDS
107 HSPA+ AT Commands Reference Guide
+CGQREQ: ”IP”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
3G Quality of Service Profile (Requested) +CGEQREQ
Set command specifies a 3G quality of service profile for the context identified by the(local) context identification
parameter which is used when the MT sends an Activate PDP Context Request message to the network.
Read command returns the current settings for each defined context in the format:
[+CGEQREQ: ,,,,bitrate UL>,,,,ratio>,,,delay>,,,indication>] [+CGEQREQ:…]
If no PDP context is defined, it has no effect and OK result code is returned.
Test command returns as a compound value the type of the current PDP context and the supported values for the
subparameters in the format:
+CGQEQREQ: ,(list of supported s),
(list of supported s),(list of supported DL>s),(list of supported s),(list of supported bitrate DL>s),(list of supported s),(list of supportedsize>s),(list of supporteds),(list of supportedratio>s),(list of supported s),(list of supported
s),(list of supported s), (list of
supported s), (list of supported indication>s)
Note: Only “IP” PDP_Type is currently supported.
Syntax
Command Command type
AT+CGEQREQ=
[
[,
[,
[,
[,
[,
[,
[,
[,
[,
[,
[,
[,
[,
[,]]]]]]]]]]]]]]]
AT+CGEQREQ? Read
AT+CGEQREQ=?