Synaccess Networks NP-0801DTM - Manual (Page 171)

CUSTOM AT COMMANDS
171 HSPA+ AT Commands Reference Guide
Syntax
Command Command type
AT#ACAL=[] Set
AT#ACAL? Read
AT#ACAL=? Test
Parameters and Values
0 Disables the automatic call function. Default: 0.
1 Enables the automatic call function. If enabled (and &D2 is issued), the transition
OFF/ON of DTR causes an automatic call to the first number (position 0) stored in
the internal phonebook.
Notes
„
Type of call depends on the last issue of command +FCLASS.
„
See &Z to write and &N to read the number on module internal phonebook.
Extended Automatic Call #ACALEXT
Set command enables or disables the extended automatic call function.
Read command reports either whether the automatic call function is currently enabled or not, and the last
setting in the format:
#ACALEXT: ,
Test command returns three ranges of values, because the range of available positions in a phonebook depends
on the selected phonebook.
„
„
when the internal phonebook is selected.
„
when “SM” is the selected phonebook.
Syntax
Command Command type
AT#ACALEXT=, Set
AT#ACALEXT? Read
AT#ACALEXT=? Test