Apple Final Cut Pro 6 - Manual (Page 1693)

210 Part III Output
To do an assemble edit:
1 Choose File > Edit to Tape.
In most layouts, the Edit to Tape window appears on top of the Canvas.
2 Choose Editing or Mastering mode from the pop-up menu in the top center of the window.
For more information about the Editing and Mastering modes, see “ Video Tab ” on
page 201.
3 Select a clip or sequence in the Browser.
4 If you haven’t already done so, set In and Out points for your clip or sequence in the
Viewer, if you don’t want to output the entire clip or sequence.
5 In the Edit to Tape window, cue the tape where you want to start your initial edit, then
press I, click the Mark In button, or type a value and press Return.
Note: You do not need to set an Out point for an assemble edit.
The preview option is
disabled if you are using
DV equipment.
Choose a mode from this
pop-up menu.
If desired, set In and Out
points for the part you
want to record.