Spectra Precision FAST Survey Reference Manual - Manual (Page 362)

p360
 Channel
: Specifices the channel of the GeoRadio.
 Station Address:
Specifies the station address of the GeoRadio.
 Remote Address
: Specifies the remote address of the instrument's radio.
Putting the 600 in the “Remote Mode”
1.
# Power the 600 on.
2.
# Answer the initial questions.
3.
# If you have not selected the Radio Channels and Address, do the following:
4.
# Press
5.
# <1> for Set.
6.
# <5> for Radio.
7.
# Select Channel (1-8).
8.
# Select Station Address (1-99).
9.
# Select Radio Address (1-99).
10.
# Press .
11.
# Press <3> for Remote.
12.
# Press <1> for OK.
13.
# Press for Sector.
14.
# Press for Measure Ref Object.
15.
# Press any key when prompted. You do not have to remove the keyboard as prompted unless you are using the
Direct Robotic option instead of GeoRadio. FAST Survey will control the total station.
Total Station (Leica TPS Series)
This series covers most of the current Leica total stations such as TPS 100, TPS 300, TPS 700, TPS 700 auto, Builder,
TPS 400, TPS 800, TPS 1000 (including TC1010 and TC1610,) TPS 1100,and TPS 1200. For the older 600 and 900,
turn off ATR and use the TPS 100/300 configuration. Many of these units include the “motorized” option. Some
settings may vary by model.
 Comm Setup:
Default settings for these instruments are a baud rate: 19200, none parity, Char Length: 8 and Stop
Bits:1
 Instrument Series:
Instruments supported are TPS 100, TPS 300, TPS 700, TPS 700 auto, Builder, TPS 400, TPS
800, TPS 1000 (including TC1010 and TC1610,) TPS 1100,and TPS 1200