Spectra Precision FAST Survey Reference Manual - Manual (Page 198)

p196
Auto by Interval
allows you to acquire and store data at a set interval value of either distance or time. This function is
available with all GPS or certain robotic total stations only. When the routine is selected using a robotic total station
with Prompt for Setup within Configure on, you will be directed to a Confirm Orientation dialog, in which you will be
asked to confirm your orientation. The opening or main dialog appears as shown below.
After the backsight is confirmed or measured, the Auto Store by Interval dialog will appear as shown in the figure
below. In GPS mode, you will see the Auto Store by Interval dialog immediately. In the Auto Store by Interval dialog
box, you set the type of interval (distance or time) and the value of the interval. You also set the starting point number
for the data set. You can assign a point description for all points acquired with this command. During actual data
collection, you can change the description.
Data is acquired in the standard collection MAP view screen. The point ID, description, and rod height fields can all be
changed while the command is active. For example, to change your point description from td (top of ditch) to gr
(ground shot), simply type "gr" over the "td" in the Desc field without interrupting your collection.