Spectra Precision FAST Survey Reference Manual - Manual (Page 163)

p161
With Stake Station Interval On, the alignment selection screen continues into the Station/Offset screen where you select
your station and offset to stake out. Using Define Alignments, the Point on Line option becomes Point on CL in the
screen that follows. With both horizontal and vertical alignments defined, the final stakeout screen (eg. station 375)
includes cut and fill values. Shown below is an example in GPS mode. The centerline was picked from the screen
(Select Polyline) and the vertical alignment was selected from a file.
Stake Station Interval On
Reference Centerline Example
If a Master Centerline or "Reference Alignment" is used and Stake Station Interval is Off, and "Use Reference
Centerline to Display Station and Offset" is on, you will obtain the cut/fill from the target alignment but the Station and
Offset, noted with the "*" symbol, from the Reference Centerline: