Spectra Precision FAST Survey Reference Manual - Manual (Page 328)

p326
Offset Settings (OF):
This command allows you to set the type of corner that FAST Survey should create when offsetting entities.
Align Settings (ABSET):
This command allows you to select between two methods of aligning buildings using the Align Building command
under Draw, Transform. The first method (offset-distance) aligns buildings parallel to the sideline based on a sideline
offset and a distance offset along the sideline to the front of the building. The second method (offset-offset) holds the
building parallel to the sideline but ensures that the frontage offset to the selected corner of the building matches the
second offset value.
Traverse Defaults (TD):
This sets the elevation prompting (none, vertical, zenith, elevation difference), within the Traverse and Sideshot
commands within the MAP view. Also enables a prompt for Instrument and Rod Height. Default setting is no
instrument or rod heights and no vertical angle prompting, so inputs are simplified as angle/bearing code, angle/bearing,
distance, description, point number. Traverse and Sideshot entries within the MAP screen are stored to the RW5 file.
Note:
3D MODE must be enabled in Equip/Configure for this dialog to become active. Otherwise, choices are "grayed
out."