Spectra Precision FAST Survey Reference Manual - Manual (Page 342)

p340

Req
: Requisite/required entry. Operator cannot leave any GIS prompt empty when this field is set to Yes.
To add GIS attribute prompting for List Values, select the “Add” button within the New attribute dialog, as shown
immediately below. The figure below that shows the New value pop-up box. The operator inputs, after selecting Add
again, for each possible material (e.g. macadam, concrete, brick, stone cobbles and so on).
The data input for all GIS List Values is shown in following figure below. Note that Macadam is highlighted and will
be the default value. If there are more than six attribute List Values, scroll bars will appear. This defines only one GIS
entry Material for the EP field code. Each GIS prompt for the field code EP (e.g. Material, Location, Condition, Width,
Slope and so on) will require being created using Add in the Feature pop-up box, as shown earlier in this tutorial.
Add, Remove, Up and Down pertain to GIS List Values prompting. Add and Remove create or delete List Values
entries. Up or Down reorders the highlighted List Value up or down. OK exits the GIS prompting screen retaining the
GIS prompting entries and Cancel exits and discards all new inputs. The completed GIS field code for EP is shown