Spectra Precision FAST Survey Reference Manual - Manual (Page 348)

p346
The sequence of shoots started with GPS Simulation storing points 2 and 3 as EP codes. Point 3 was stored as EP END.
A 3D Polyline was drawn between 2 to 3 and GIS prompting popped-up after point 3 was stored shown above. Note in
the Condition field the operator input data not found in the default settings. Point 4 was stored using manual total
station as a UP point code. Point 4’s UP GIS prompting appeared after point 4 was stored. Points 5 through 7 were
stored as a closed polygon. This was done by storing point 7 as EP1 CLO to close back to the start point 5 of the EP1
3D Polyline. The GIS prompting appeared for EP1 (not shown) and entered. The last sequence above was to exit Store
Points and select MAP.
Editing GIS Information on Arcs and Polygons – Input-Edit GIS Data
To edit existing GIS information stored on Arcs (2D/3D Polylines) or Polygons (closed 2D/3D Polylines) in the MAP
pop-up box, select Tools – Edit – Input/Edit GIS Data, and pick any polyline or polygon. There are two figures below.
The top figure shows how the closed 3D Polyline between points 5, 6 and 7 was selected using this command. GIS data