3 psc operation modes, 1 psc in uart mode, Psc operation modes -39 – Freescale Semiconductor MPC5200B User Manual
Page 555: Psc in uart mode -39, Psc modes overview -39, Clock short cuts -39, Section 15.3, psc operation modes, Section 15.3.1, psc in uart mode
MPC5200B Users Guide, Rev. 1
15-44
Freescale Semiconductor
PSC Operation Modes
15.3
PSC Operation Modes
This section describes the different PSC operation modes including the pin muxing, the module configuration, signal definition and some
programming examples. All PSC are independent and can be used at the same time in different modes. But not all PSCs support all modes,
shows an overview.
In this section the following abbreviations will used as:
15.3.1
PSC in UART Mode
Select the UART mode by writing the corresponding value to the PSC Control (
) register. The PSC UART mode is the default mode
after reset. The important registers to configure the PSC for UART mode are:
•
register - select the UART mode
•
register - select the clock source
•
register - select the Baud rate
•
register - select the UART mode (parity mode, bits per character)
•
register - select RTS and CTS control, Stop Bit Length
•
TFALARM
- select the FIFO “Alarm” level
•
register - enable or disable receiver and transmitter
•
Port_config - select the right Pin-Muxing, see
Chapter 2, Signal Descriptions
15.3.1.1
Block Diagram and Signal Definition for UART Mode
The
Figure 1-1
shows the simplified Block Diagram of the PSC for UART mode.
Table 15-73. PSC Modes Overview
PSC1
PSC2
PSC3
PSC4
PSC5
PSC6
UART
yes
yes
yes
yes
yes
yes
Modem / SPI / I2S
yes
yes
yes
no
no
yes
Mclk Generation
yes
yes
yes
no
no
no
AC97
yes
yes
no
no
no
no
IRDA
no
no
no
no
no
yes
“Cell Phone”
master
slave
slave
no
no
slave
Table 15-74. Clock Short Cuts
Short Cut
Description
f
system
Clock from the system PLL
Mclk
Clock from the Mclk divider, used as clock input for internal clock generation
or as clock output to an external device. Before modify the counter value the
Mclk divider must be disable. See
Section 5.5.11, PSC1 Mclock Config
to
Section 5.5.14, PSC6 (IrDA) Mclock Config
IP bus Clock
Intellectual Property Clock for the internal IP bus system, 33, 66 or 132 MHz,
see
Mclk
=
MclkDiv[8:0] +1
f
system