Dell POWEREDGE M1000E User Manual

Page 846

818

Fabric OS Command Reference

53-1002746-01

portShow

To display a tunnel on a Brocade FX8-24 with automatic compression enabled:

switch:admin> portshow fciptunnel 1/21
Tunnel ID: 1/21
Tunnel Description:
Admin Status: Enabled
Oper Status: Up
Compression: On (Auto-Mode)
Fastwrite: Off
Tape Acceleration: Off
TPerf Option: Off
IPSec: Disabled
QoS Percentages: High 50%, Med 30%, Low 20%
Remote WWN: Not Configured
Local WWN: 10:00:00:05:1e:52:fe:00
Peer WWN: 10:00:00:05:1e:39:a4:76
Circuit Count: 2
Flags: 0x00000000
FICON: Off

To display a tunnel on a Brocade FX8-24 with automatic compression enabled in summary view (The "A"
flag indicates Auto-Mode:

switch:admin> portshow fciptunnel 1/21 -s
---------------------------------------------------------------------
Tunnel Circuit OpStatus Flags Uptime TxMBps RxMBps ConnCnt CommRt Met
---------------------------------------------------------------------
1/21 - Up A------ 31m29s 0.00 0.00 2 - -
1/21 0 1/xge1 Up ---4--s 31m29s 0.00 0.00 2 2500/2500 0
1/21 1 1/xge0 Up ---4-xs 31m29s 0.00 0.00 2 2500/2500 1
----------------------------------------------------------------------
Flags: tunnel: c=compression m=moderate compression
a=aggressive compression
A=Auto compression f=fastwrite t=Tapepipelining F=FICON
T=TPerf i=IPSec l=IPSec Legacy
Flags: circuit: s=sack v=VLAN Tagged x=crossport 4=IPv4 6=IPv6
L=Listener I=Initiator

To display a tunnel on a Brocade FX8-24 with IPSec enabled in legacy mode:

switch:admin> portshow fciptunnel 1/12
-------------------------------------------
Tunnel ID: 1/12
Tunnel Description:
Admin Status: Enabled
Oper Status: Up
Compression: Off
Fastwrite: Off