Dell POWEREDGE M1000E - Manual (Page 664)

636 Fabric OS Command Reference
53-1002746-01
portCfg
2
To delete an IP interface for a failover crossport:
switch:admin> portcfg ipif 8/xge0 delete 192.168.11.20 -x
Operation Succeeded
To create a static IP route using an IPv4 destination address, a netmask, and a gateway address:
switch:admin> portcfg iproute ge0 create \
192.42.0.0 255.255.255.0 192.168.0.250
Operation Succeeded
To create a static IP route using IPv6:
switch:admin> portcfg iproute ge0 create \
2010::/64 2000::1:250
Operation Succeeded
switch:admin> portshow iproute ge0
Port: ge0
IP Address Mask Gateway Metric Flags
-------------------------------------------------------------
192.42.0.0 255.255.255.0 192.168.0.250 0 U G
192.168.0.0 255.255.255.0 * 0 U C
192.168.0.10 255.255.255.255 * 0 U H L
192.168.0.11 255.255.255.255 * 0 U H L
192.168.0.21 255.255.255.255 * 0 U C
192.168.0.250 255.255.255.255 * 0 U H L
IPv6 Address Len Gateway Metric Flags
------------------------------------------------------------
2000:: 64 * 0 U C
2000::10 128 * 0 U H L
2000::11 128 * 0 U H L
2000::1:250 128 * 0 U H L
2001:: 64 2000::1:250 0 U G
fe80:: 64 * 0 U C
ff01:: 32 * 0 U C
ff02:: 32 * 0 U C
Flags: U=Usable G=Gateway H=Host C=Created(Interface) S=Static
L=LinkLayer(Arp)
To create an IP route for a failover crossport on a Brocade FX8-24:
1. Configure the iproute for the local XGE port (xge0).
switch:admin> portcfg iproute 8/xge0 create 2.2.2.0 \
255.255.255.0 192.168.11.250
Operation Succeeded