Dell POWEREDGE M1000E - Manual (Page 22)

xxii Fabric OS Command Reference
53-1002746-01
The following commands and associated man pages have been corrected or updated with additional
information:
•
aaaConfig - Added support for TACACS+.
•
ag - Added options to save the configured F_Ports, delete the backup mappings for the given
N_Port, and display the saved mappings for the given N_Port.
•
aptPolicy - Added support for Device-based routing in FICON environments.
•
auditDump - The CLI audit is captured.
•
bottleneckMon - Added option to configure the BE credit Loss Link Reset Threshold.
•
cfgShow - Added new option to display the changes in the transactions.
•
cfgTransShow - Added new option to display local open transaction token details and the list of
domains with open transactions.
•
classConfig - Added the command restriction details dispalyed with the -showcli option.
•
cliHistory - Added new new options to display the CLI history of the specified users.
•
configureChassis - Added the CS_CTL to virtual channel mapping options.
•
dlsSet - The Losseless (or fmsmode) can be enabled when XISL is enabled and vice versa.
•
dnsConfig - Added options to set the DNS configuration parameters through the CLI. Also
added options to delete and display the DNS configuration.
•
errDump - Added options to display messages for the entire chassis, to display messages
based on count value, to display messages in reversed order, to display messages based on
severity, and to display messages based on slot.
•
fcrFabricShow - Added option to display the FC Routers on a backbone fabric with edge fabric
names.
•
fcrPhyDevShow - Added the help option.
•
ficonCupShow - Added options to display the FICON-CUP missing interrupt handler primary
timeout (MIHPTO) value in seconds, to display the Director Diagnostics Log, to display dignostic
information, and to display HealthCheck Logs for the logical switch.
•
ficonShow - Added options to display RNID data in table format, and to display RNID data for
only the specified port.
•
ifModeSet - Added options to configure autonegotiation, speed, and capability. Also added the
help option.
•
islShow - The output is modified to display the neighbor WWN information even when the ISL is
segmented during exchange link parameter (ELP) or post ELP segmentation phase.
•
licensePort - The restriction that the command is supported only on embedded platforms is no
longer applicable.
•
nsAliasShow - Added option to display the remote device details for a specific domain. Also
added the help option.
•
nsZoneMember - Added help option.
•
pathInfo - Added options to specify the source ID of the originator and the destination ID of the
proxy device.
•
portCfg - Added option to configure auto-negotiation settings for 1 GbE ports.
•
portCfgAutoDisable - Added options to suspend and resume the port autodisable
configuration.
•
portCfgCreditRecovery - Command is supported in Access Gateway mode.