Dell POWEREDGE M1000E - Manual (Page 346)

318 Fabric OS Command Reference
53-1002746-01
fcpRlsProbe
2
fcpRlsProbe
Initiates the Fibre Channel Protocol (FCP) Read Link Status (RLS) probing for F_Port and displays the
RLS information.
SYNOPSIS fcpRlsProbe --start [slot/]port_list
fcpRlsProbe --show [slot/]port
fcpRlsProbe --help
DESCRIPTION Use this command to initiate the FCP RLS probing or to display the RLS information. This information
describes the number of link failures, loss-of-signal, loss-of-sync, CRC errors, and other failure events
detected on the specified port.
Use the fcprlsprobe --start command to read the error status block for F/FL-Ports. This command will
send a RLS ELS probe to the device on the specified port and caches the RLS information. Use the
fcprlsprobe --show command to display the cached RLS information. For the command to send RLS
probe to the device you must enable the following parameter: Disable Device Probing = 0 (Enables
device probing. By default Device probing is enabled).
For this command to gather and display F_Port error statistics, apart from enabling the device probing,
you must enable RLS Probing using the fcprlsprobe --start command or use the configure command,
"Disable RLS Probing". By default, RLS probing is disabled.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operands:
slot
Specifies the slot number, if applicable, followed by a slash (/).
port_list
Specifies a port number. You can specify a port or range of ports.
--start
Sends the ELS RLS to the device and gets the RLS information.
--show
Displays the RLS information.
--help
Displays the command usage.
EXAMPLES To start the RLS probing:
switch:admin> fcprlsprobe --start 1
RLS probing initiated...
Please use the fcprlsprobe --show
port command to view the RLS info.
To view the RLS information:
switch:admin> fcprlsprobe --show 1
Rls Probing Statistics for port 1
====================================
AL_PA 0x0
---------
RLS Probe Status : SUCCESS