Dell POWEREDGE M1000E - Manual (Page 830)

802 Fabric OS Command Reference
53-1002746-01
portShow
2
--lifetime
Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the
associated TCP connections. This option will ignore any time based deltas
that were created previously set using the --reset option.
-q | --qos
Displays the QoS statistics including performance for each priority. This operand
is optional with the --perf option.
-i | --ipsec
Displays IPSec status (enabled or disabled) and key if enabled. If IPSec is
enabled and configured in legacy mode, the mode information is displayed in
parenthesis. This option is valid for portShow fciptunnel only.
-h | --hier
Displays the FCIP tunnel hierarchy listing basic circuit IDs and TCP connection
information for the tunnel.
-s | --summary
Displays a summary view of the tunnel configuration parameters for a specific
VE_Port. You can use the summary option with the -perf and the - qos option.
When used with the -perf option, the summary option forces the --circuit option.
Flags indicate ipsec-configured tunnels, legacy ipsec tunnels, and compression
mode. Circuit flags indicate vlan tagging, crossport configuration, and ipv4 or ipv6
configuration.
-d | --detail
Displays a full view configuration details for all configured tunnels when used with
the all port specifier. This view provides an alternative to specifying a specific
VE_Port or to using the --perf option for a comprehensive view.
-I | --ip-address
Displays the IP addresses configured the specified circuits. You must use this
option with either the --summary or the --circuit option.
fcipcircuit
Displays FCIP circuit configuration and status. The following operands are
supported with portShow fcipcircuit:
circuit_ID
Specifies a single circuit within the FCIP tunnel. The circuit ID is an integer value
between 1 and 19 on the Brocade FX8-24 and 1 and 7 on the Brocade 7800. This
operand is required.
-t | --tcp
Displays the TCP statistics for the specified circuit.
--reset
Displays time based set of statistics.
--lifetime
Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the
associated TCP connections. This option will ignore any time based deltas
that were created previously set using the --reset option.
-p | --perf
Displays additional performance information for the specified FCIP circuit.
--lifetime
Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the
associated TCP connections. This option will ignore any time based deltas
that were created previously set using the --reset option.