Dell POWEREDGE M1000E - Manual (Page 1078)

1050 Fabric OS Command Reference
53-1002746-01
thConfig
2
EE
Monitors the End-to-End Performance Monitor class. Valid areas for the EE class
include the following:
RXP
Monitors receive performance as the percentage of word frames traveling
from the configured SID to the DID.
TXP
Monitors transmit performance as the percentage of word frames traveling
from the configured DID to the SID.
--set class -area area
Configures Fabric Watch thresholds for monitoring a specified class and area.
When configuring Fabric Watch thresholds, you must specify a class and an area.
The following operands are optional and valid only with the --set option; if omitted,
the default Fabric Watch configuration is used. Default parameters vary
depending on the area and platform. Refer to the Fabric Watch Administrator's
Guide for specific details.
-timebase time_base
Specifies the time interval between two samples to be compared. Valid intervals
include the following:
day
Samples are compared once a day.
hour
Samples are compared once every hour.
minute
Samples are compared once every minute.
none
Samples are not compared.
-sfptype sfp_type
Configures and manages thresholds and alerts for 10G SFPs, 16G SFPs and 16G
QSFPs. Fabric Watch applies thresholds based on the serial numbers of the SFP
types. If the SFP serial number cannot be determined, Fabric Watch applies
pre-Fabric OS v7.0.0 thresholds. This operand is optional and supported only on
Condor 3-based platforms; if omitted, legacy thresholds and actions apply to 8G
SPPs. Valid SFP types include the following:
16GSWL
Brocade-branded 16G SFP with serial number HA.
16GLWL
Brocade-branded 16G SFP with serial number HD.
QSFP
Brocade-branded 16G QSFP.
10GSWL
Brocade-branded 10G SFP with serial number KA.
10GLWL
Brocade-branded 10G SFP with serial number KD.
-highth -value value
Specifies the high threshold value for triggering a specified alert action. To
change the default value, provide an integer value.