Dell POWEREDGE M1000E - Manual (Page 498)

470 Fabric OS Command Reference
53-1002746-01
ipAddrShow
2
-
tentative
-
preferred
-
deprecated
Refer to the RFC 2462 specification for more information.
On modular platforms with intelligent blades, the addresses configured for each slot can be shown with
the -slot option. On standalone platforms, all command options are ignored.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operands:
-cp cp_number
On dual-CP systems, specifies the CP card number to be displayed (0 or 1).
-chassis
On dual-CP systems, displays the IP addresses for the chassis.
-slot slot
Specifies the slot for a blade.
-eth0 | -eth1 | -gate
For a specified slot, shows only the selected Ethernet interface or the gateway .
This operand is optional with the -slot option.
EXAMPLES To display the IP addresses on a standalone switch:
switch:admin> ipaddrshow
SWITCH
Ethernet IP Address: 10.20.21.204
Ethernet Subnetmask: 255.255.240.0
Gateway IP Address: 10.20.16.1
DHCP: Off
IPv6 Autoconfiguration Enabled: Yes
Local IPv6 Addresses:
dhcpv6 fd00:60:69bc:82:a6f3:568b:a9cc:a149/64 preferred
stateless fd00:60:69bc:82:205:33ff:fe94:771f/64 preferred
IPv6 Gateways:
fe80::21b:edff:fe0b:2400
fe80::21b:edff:fe0b:7800
DHCPv6: On
To display all IP addresses on a Brocade DCX backbone:
switch:admin> ipaddrshow
Chassis
Ethernet IP Address: 10.33.60.85
Ethernet Subnetmask: 255.255.240.0
CP0
Ethernet IP Address: 10.33.60.86
Ethernet Subnetmask: 255.255.240.0
Host Name: cp0
Gateway IP Address: 10.33.48.1
CP1
Ethernet IP Address: 10.33.60.87