Portswapshow – Dell POWEREDGE M1000E User Manual
Page 884
856
Fabric OS Command Reference
53-1002746-01
portSwapShow
2
portSwapShow
Displays the state of the PortSwap feature.
SYNOPSIS
portswapshow
DESCRIPTION
Use this command to display the state of the PortSwap feature and information about swapped ports. If
portSwap is enabled and ports have been swapped, the command displays the enabled status as well
as the swapped ports and the new port address (the 24-bit PID) for these ports. If portSwap is disabled,
the command shows the disabled status and indicates whether or not swapped ports exist on the switch.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
None
EXAMPLES
To display a switch with PortSwap enabled and information for swapped ports:
Console message:
2009/10/09-21:22:45, [PSWP-1001], 482, SLOT 6 | FID 51, INFO,
DCX_105_51, PID for port 12/0 and port 12/63 are swapped.
New PID for port 12/0 is 0x697000 and port 12/63 is 0x69e3c0.
switch:admin> portswapshow
PortSwap is enabled
Slot Slotport Swport Address
============================================
12 0 112 0x697000
12 63 895 0x69e3c0
To display the portSwap status on a switch when the feature is disabled and no ports are swapped:
switch:admin> portswapshow
PortSwap is disabled.
Existing Portswap condition is still effective.
Only future Portswap operations are not allowed.
No ports have been swapped
SEE ALSO
,
,
,
,