Dell POWEREDGE M1000E - Manual (Page 736)

708 Fabric OS Command Reference
53-1002746-01
portCfgShow
2
3
Autonegotiated or fixed port speeds of 16 Gbps and 10 Gbps.
Speed
Displays Auto for auto speed negotiation mode, or a specific speed of 1, 2, 4, or 8
Gbps. This value is set by the portCfgSpeed command.
Fill Word (On Active)
Displays the fill word setting that will take effect after the next time the port goes
offline and comes back Possible values are 0(Idle-Idle), 1(arbff-arbff), 2(Idle-arbff),
or 3(A-A then SW I-A).This parameter is set by the portcfgFillword command.
Fill Word (Current)
Displays the currently effective fill word setting. Possible values are 0(Idle-Idle),
1(arbff-arbff), 2(Idle-arbff), or 3(A-A then SW I-A). This parameter is set by the
portcfgFillword command.
AL_PA Offset 13
Displays (..) or OFF when the arbitrated loop physical address (AL_PA) on the
port is configured to use a 0x0 AL_PA address (default). Displays ON when the
address configuration is 0x13 AL_PA. This value is set by the portCfgAlpa
command.
Trunk Port
Displays ON when port is set for trunking. Displays (..) or OFF when trunking is
disabled on the port. This value is set by the portCfgTrunkPort command.
Long Distance
Displays (..) or OFF when long distance mode is off; otherwise, displays long
distance levels. This value is set by the portCfgLongDistance command. Values
are as follows:
LE
The link is up to 10 km.
LM
The link is up to 25 km.
L1
The link is up to 50 km.
L2
The link is up to 100 km.
LD
The distance is determined dynamically.
LS
The distance is determined statically by user input.
VC Link Init
Displays (..) or OFF when the long distance link initialization option is turned off.
Displays ON when it is turned on for long distance mode. This value is set by the
portCfgLongDistance command.
Desired Distance
Displays the desired distance of the port. This field is displayed only when
portCfgShow is executed for a single port and would only display for LS and LD
long distance mode.
Reserved Buffers
Displays the reserved buffers for the port. This field is displayed only when
portCfgShow is executed for a single port and would only display for LS and LD
long distance mode.