Dell POWEREDGE M1000E - Manual (Page 1156)

1128 Fabric OS Command Reference
53-1002746-01
Command Admin Domain and Virtual Fabrics restrictions
A
Virtual Fabric commands are further constrained by one of the following switch types:
-
All Switches (All) = Command can be run in any switch context.
-
Base Switch (BS) = Command can be run only on the base switch.
-
Default Switch (DS) = Command can be run only on the default switch.
-
N/A = Switch type is not applicable to the command.
-
Chassis context (CH) = Command applies to the chassis on which it is executed.
-
Switch and Chassis context (VF/CH) = Command applies to the switch and the chassis.
-
Disallowed = Command cannot be executed when Virtual Fabrics are enabled.
5. Command-specific: Checks whether the command is supported on the platform for which it is
targeted.
NOTE
To determine RBAC permissions for a specified command and associated major options,use the
classConfig --showcli command. Refer to
Chapter 1, “Using Fabric OS Commands” for more
information.
Command Admin Domain and Virtual Fabrics restrictions
TABLE 1 Admin Domain and Virtual Fabric restrictions for Fabric OS commands.
Command name Admin Domain Context Switch type
aaaConfig SwitchMember CH N/A
ad Allowed/Phys Fabric only Disallowed N/A
ag N/A/ Allowed/ SwitchMember VF All
agAutoMapBalance N/A/ Allowed/ SwitchMember VF All
agShow Allowed VF All
aliAdd Allowed VF All
aliCreate Allowed VF All
aliDelete Allowed VF All
aliRemove Allowed VF All
aliShow Allowed VF All
appLoginHistory Allowed/ SwitchMember VF All
aptPolicy SwitchMember VF All
auditCfg SwitchMember CH N/A
auditDump SwitchMember CH N/A
authUtil Allowed/ SwitchMember VF All
bannerSet SwitchMember VF N/A
bannerShow Allowed VF N/A
bcastShow Allowed VF All
bladeCfgGemode PortMember CH N/A
bladeDisable SwitchMember CH N/A
bladeEnable SwitchMember CH N/A