Dell POWEREDGE M1000E - Manual (Page 377)

Fabric OS Command Reference 349
53-1002746-01
fcrXlateConfig
2
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
Information displayed is not related to the entire backbone. The FC Router displays only connections to
an edge fabric for which there are translate domain IDs. Any changes you intend to make using this
command should be issued on the switches to which the edge fabrics are directly attached. In a Virtual
Fabric environment, this is the base switch.
OPERANDS This command has the following operands:
fcrxlateconfig
Sets the preferred domain ID (1-239) to preferredDomainID for the translate
phantom domain and saves the configuration persistently. The translate domain
must be inactive to set the preferred domain ID. The following operands are
required:
importedFID
Specifies the fabric ID (1 through 128) of the fabric that contains the translate
domain.
exportedFID
Specifies the fabric ID (1 through 128) of the remote fabric represented by this
translate domain.
preferredDomainID
Specifies the preferred domain ID (1 through 239) of the translate phantom
domain.
--remove | -r
Removes the preferred domain ID of the translate phantom domain. The translate
domain must be inactive to remove the preferred domain ID. The following
operands are required:
importedFID
Specifies the fabric ID (1 through 128) of the fabric that contains the translate
domain.
exportedFID
Specifies the fabric ID (1 through 128) of the remote fabric represented by this
translate domain.
preferredDomainID
Specifies the preferred domain ID (1 through 239) of the translate phantom.
--enable persistxd
Enables translate domain persistence. When persistxd is enabled, the translate
domain is created based on the persistent translate domain ID configuration. If a
valid persistent translate domain ID is configured for a given importedFID and
exportedFID pair, a translate domain for the exportedFID is created, even if no
devices need to be imported or exported across the edge fabrics represented by
importedFID and exportedFID. By default, persistxd is enabled.
--disable persistxd
Disables translate domain persistence. When persistxd is disabled, the translate
domain is not created, even if a valid persistent translate domain ID is configured
for the importedFID and exportedFID pair, so long as no devices are imported or
exported across the edge fabrics represented by importedFID and exportedFID.
Once devices need to be imported or exported across the edge fabrics, the
translate domain is created.