Dell POWEREDGE M1000E - Manual (Page 466)

438 Fabric OS Command Reference
53-1002746-01
haSyncStart
2
haSyncStart
Enables High Availability state synchronization.
SYNOPSIS hasyncstart
DESCRIPTION Use this command to enable the High Availability (HA) state synchronization.
After issuing haSyncStop, the switch does not go back to sync start unless you perform one of the
following actions: reboot the active CP, reboot the standby CP, insert a new standby CP (blade), or issue
the haSyncStart command The time it takes for the HA sync to complete depends on the system
configuration. The HA sync timeout is set to 10 minutes.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
EXAMPLES To enable the HA state synchronization:
switch:admin> hasyncstart
SEE ALSO haFailover , haShow , haSyncStop