Dell POWEREDGE M1000E - Manual (Page 433)

Fabric OS Command Reference 405
53-1002746-01
frameLog
2
--show
Prints a listing of details about stored frames that match the specified filter criteria.
This operation is permitted only when the feature is enabled. You can specify one
or more of the following options to filter the output. When used without operands,
the --show command displays the unfiltered output. This option supports
specifying that the TX port or RX port of displayed frames should be a backend
port.
-txport [slot/]port
Displays only the frames that were bound to exit by the specified egress port. The
-txport option accepts argument "-1" (for fixed-port switches) or "-1/-1" (for
modular switches). These stand for "any backend port". Using this notation, you
can select specifically those discarded frames that have a backend port in the TX
port field. Individual backend ports cannot be specified, only the quality of being a
backend port can be specified.
-rxport [slot/]port
Displays only the frames that entered the chassis on the specified port. The
-rxport option accepts argument "-1" (for fixed-port switches) or "-1/-1" (for
modular switches). These stand for "any backend port". Using this notation, you
can select specifically those discarded frames that have a backend port in the RX
port field. Individual backend ports cannot be specified, only the quality of being a
backend port can be specified.
-sid source_PID
Displays only the frames with the specified 24-bit source address in the FC
header. The port ID (PID) must be written in hexadecimal and must be prefixed by
0x.
-did destination_PID
Displays only the frames with the specified 24-bit destination address in the FC
header. The port ID (PID) must be written in hexadecimal and must be prefixed by
0x.
-sfid fabric_ID
Displays only the frames with the specified fabric ID as the source fabric ID.
-sdfid fabric_ID
Displays only the frames with the specified fabric ID as the destination fabric ID.
-mode summary | dump
Specifies the command output mode. In dump mode, the command prints the 64
bytes of frame contents. In summary mode, the frame contents are not displayed.
Summary mode is the default.
-n num_items
Displays the specified number of items. In summary mode, an item is a record of
frames with the same values of log timestamp, TX port, RX port, SID, DID, SFID
and DFID. Note that more frames may be represented in the lines of output than
specified in the num_items value, because one line can aggregate multiple frames
in summary mode. In dump mode, each item represents a single frame. The
default value of num_items is 20. The maximum value in summary mode is 1200,
and in dump mode it is 12,000.
EXAMPLES To display eight lines of an unfiltered frame log view in summary mode:
switch:user> framelog --show -mode summary -n 8
=====================================================================
Mon Jan 31 23:54:59 UTC 2011
======================================================================
Log TX RX