Dell POWEREDGE M1000E - Manual (Page 658)

630 Fabric OS Command Reference
53-1002746-01
portCfg
2
portCfg
Manages port configuration parameters for FC ports, VE_ports, and GbE/10GbE ports.
SYNOPSIS portcfg action [slot/] port arguments
portcfg action [slot/] ge_port arguments
portcfg action [slot/]ve_port options arguments
portcfg action [slot/][ge_port options arguments
DESCRIPTION Use this command to manage port configuration parameters on FC ports as well as on Gigabit Ethernet
(GbE) ports on the Brocade 7800 switch and on the Brocade FX8-24 blade.
You must use this command in a manner that honors the platform-specific differences in command
syntax and behavior. Some command options are not available on all platforms. Others behave
differently depending on the platform on which they are executed. Use the following section headings to
navigate this page.
Commands supported on all platforms
•
portcfg mirrorport - Configure a mirror port on the local FC port.
•
portcfg rscnsupr - Manage registered state change notification (RSCN) suppression on the local
port.
Configure IP interfaces on the Brocade 7800 switch and FX8-24 blade
•
portcfg ipif - Configure the local IP interfaces
•
portcfg iproute - Configure a static route on the IP interface.
•
portcfg vlantag - Manage the IP interface VLAN configuration for FCIP.
Configure tunnels, circuits, and management interfaces on the Brocade 7800/FX8-24
•
portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels
•
portcfg fcipcircuit - Create, modify, and delete FCIP circuits.
•
portcfg mgmtif - Creates the inband management interfaces.
•
portcfg mgmtroute - Creates the routes for the inband management interfaces.
•
portcfg autoneg - Configure autonegotiation settings for 1 GbE ports.
To display the command usage on the switch, execute portcfg action without any further arguments.
NOTES IPv6 addresses are supported except for inband management. IP Security enabled FCIP Tunnels cannot
use IPv6 circuits.
In Fabric OS v7.0.0, the restrictions on addressing have been lifted. An IPv4 subnet can span multiple
GbE interfaces, and you can now have multiple IPv6 addresses with the same prefix configured on
different GbE interfaces on the same extension switch or blade.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
Some of the features supported by this command may require a license.
The Fabric OS port configuration commands are not supported on FCoE ports.
FUNCTION Commands supported on all platforms
SYNOPSIS portcfg action [slot/]port arguments