Dell POWEREDGE M1000E - Manual (Page 492)

464 Fabric OS Command Reference
53-1002746-01
ipAddrSet
2
ipAddrSet
Sets the Ethernet and FC IP addresses.
SYNOPSIS ipaddrset [-ipv6 ] [--add x:x:x:x:x:x:x/n | --delete]
ipaddrset [-cp cp_number | -chassis]
[-ipv6 ] [--add x:x:x:x:x:x:x/n | --delete]
ipaddrset [-slot slot] [-eth0 | -eth1] [--add x.x.x.x/n | --delete]
ipaddrset [-slot slot] -gate [--add x.x.x.x | --delete]
ipaddrset -ls FID --add IPv4_address/prefix
ipaddrset -ls FID --delete
ipaddrset -ipv6 [-auto | -noauto]
ipaddrset [-cp cp_number | -chassis]
ipaddrset -cp cp_number -ipv4 -add -host hostname
-ethip ipaddress -ethmask mask
-gwyip gateway_ip
ipaddrset -ipv4 -add -ethip ipaddress -ethmask mask
-gwyip gateway_ip -dhcp [ON | OFF]
ipaddrset -chassis -ipv4 -add
-ethip ipaddress -ethmask mask
ipaddrset -ipv6 [-dhcpv6 | -nodhcpv6]
ipaddrset --help
DESCRIPTION Use this command to configure the IP addresses on a switch, a control processor (CP), a blade
processor (BP), or a standalone application processor (AP). On platforms that support Logical Fabrics,
this command configures the IPv4 Fibre Channel addresses for the logical fabric IPFC network interface.
The IPFC (IP over Fibre Channel) protocol allows switches to send IP traffic over Fibre Channel rather
than through Ethernet connections.
This command supports an interactive legacy mode and a command line interface. Use the command
line interface to configure IPv6 addresses, to enable or disable stateless IPv6 autoconfiguration, to
assign a Fibre Channel IPv4 address and prefix to a logical switch IPFC network interface, and to
configure a service port on the CP blade of a Brocade DCX. When run interactively in legacy mode, this
command sets the Ethernet IPv4 address, subnet mask, and Gateway on a switch or a chassis.
Command usage depends on the type of IP address and on the platform on which the command is run.
Some of the platform- and IP address-specific features of the command are outlined below. For complete
details, refer to the Fabric OS Administrator's Guide.
Configuring IP Addresses using the command line interface