Dell POWEREDGE M1000E - Manual (Page 796)

768 Fabric OS Command Reference
53-1002746-01
portLogShow
2
ctin
Argument 0 is divided into two 16-bit fields: [A] A bit map indicating whether
subsequent arguments are valid (0001 means argument 1 is valid, 0003 means
arguments 1 and 2 are valid). [B] The CT-based service command code.
Argument 1 is the first word of the CT payload, if applicable (as specified in [A]).
Argument 2 is the second word of the CT payload, if applicable (as specified in
[A]).
ctout
Argument 0 is also divided into two 16-bit fields: [A] a bit map indicating whether
subsequent arguments are valid (0001 means argument 1 is valid, 0003 means
arguments 1 and 2 are valid). [B] the CT command code indicating whether an
accept (8002) or a reject (8001). If [B] is an accept, argument 1 and 2 represents
the first and second words of the CT payload, if applicable (as specified in [A]). If
[B] is a reject, argument 1 contains the CT reject reason and explanation code.
errlog
Error type (refer to errShow).
loopscn
The meaning further depends on each loop state:
OLP
Offline reason code, usually zero.
LIP
Reason code for LIPs initiated by FL_Port, if the code value is 800x (x = [1,0xc],
see below), or the lower two bytes of the LIP received, if the code value is other
than 800x.
LIM
Usually zero.
BMP
Memory address for the loop bitmap.
OLD
Usually zero.
TMO
Encoded value of the state when loop initialization timed out This value is usually
equal to the first word of a loop init frame payload. Other possible values include
the following:
2
LIP (req. INITIALIZING) timeout.
94
F0F0 ARB(F0) timeout.
40
CLS timeout.
Codes used in various fields are as follows:
state
Valid state values include the following:
1
Online
2
Offline
3
Testing