Dell POWEREDGE M1000E - Manual (Page 818)

790 Fabric OS Command Reference
53-1002746-01
portShow
2
portShow
Displays status and configuration parameters for ports and GbE ports.
SYNOPSIS portshow [slot/][ge]port
portshow -i [ index1 [-index2] [...]] [-f]
portshow -x [hex1[-hex2] [...]]
portshow option [slot/]ge_port [optional_args]
portshow option [all | ve_port] arguments
[optional_arguments]
portshow option [all |ge_port] arguments
[optional_arguments]
DESCRIPTION Use this command to display general port status and specific configuration parameters for a specified
port, GbE port, or VE_Port.
If this command is executed for a specified port with no additional options, it displays general status and
configuration for that port. If executed with optional arguments for a Gigabit Ethernet (GbE) port or
VE_Port, the command displays FCIP-related port configuration parameters specific to the Brocade 7800
switch and the Brocade FX8-24 blade.
The behavior of this command is platform-specific. Some command options are not available on all
platforms. Use the following section headings to navigate this page.
•
Display general port status information on all platforms
•
Display IP Interface configurations on the Brocade 7800/FX8-24 platforms
-
portshow ipif - Displays the local IP interfaces.
-
portshow arp - Displays the content of the address resolution protocol (ARP) table.
-
portshow iproute - Displays static routes on the IP interface.
-
portshow vlantag - Displays the IP interface VLAN configuration.
•
Display FCIP tunnels, circuits, management interfaces and FICON statistics on the Brocade
7800/FX8-24 platforms
-
portshow fciptunnel - Displays Fibre Channel over IP (FCIP) tunnels.
-
portshow fcipcircuit - Displays FCIP circuits.
-
portshow mgmtif - Displays the inband management interfaces.
-
portshow mgmtroute - Displays the routes for the inband management interfaces.
-
portShow xtun - Displays FICON and FCP emulation statistics and current runtime conditions.
To display the command usage on the switch, use portShow [action].
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
Some of the features supported by this command may require a license.
In an AD context, if one of the L_Ports or NPIV ports is a part of the current AD, the complete device
information attached to the port is shown in the output.