Dell POWEREDGE M1000E - Manual (Page 983)

Fabric OS Command Reference 955
53-1002746-01
slotShow
2
DISABLED
The blade is powered on but disabled.
FAULTY
The blade is faulty because an error was detected. A fault code of 53 may also
indicate the possibility of a rolling reboot detection (RRD) on the specified blade.
In the case of an RRD, investigate and correct the cause, then reboot the control
processor (CP) to recover the blade.
UNKNOWN
The blade is inserted but its state cannot be determined.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
In a DCX-4S, slot 5 is occupied by a control processor blade (Blade ID 50). On a DCX, slot 5 is occupied
by the core blade (Blade ID 52).
OPERANDS This command supports the following operands:
-p
In addition to the basic slot status view, displays the following information about
power consumption:
•
Total direct current (DC) power consumption for the chassis and individual
values for each blade (in Watts). Usage for other components such the WWN
card or fans is included in the calculation but not listed per component. Note
that the data displayed in the "DC Power Consumption" column and in the
summary field "Total DC Power consumption" indicate the maximum allowed
power consumption, not a real-time value. Real-time power consumption data
is displayed for 16G platforms only with the chassisShow command.
•
Total alternating current (AC) power consumption in Watts. This value
indicates the maximum allowed AC power consumption; it is not a real-time
value.
•
AC efficiency, as a percentage of total and BTU.
•
Power efficiency in Watts/port and Watts/Gb.
-m
In addition to the basic slot status view, displays the Brocade model name for
each blade.
EXAMPLES To display the status of all slots on a DCX 8510-8:
switch:user> slotshow
Slot Blade Type ID Status
---------------------------------
1 SW BLADE 97 ENABLED
2 SW BLADE 96 ENABLED
3 SW BLADE 97 ENABLED
4 SW BLADE 96 ENABLED
5 CORE BLADE 98 ENABLED
6 CP BLADE 50 ENABLED
7 CP BLADE 50 ENABLED
8 CORE BLADE 98 ENABLED
9 SW BLADE 125 ENABLED
10 SW BLADE 126 ENABLED
11 SW BLADE 37 ENABLED
12 SW BLADE 55 ENABLED