Dell POWEREDGE M1000E - Manual (Page 101)

Fabric OS Command Reference 73
53-1002746-01
bladeEnable
2
bladeEnable
Enables all user ports on a blade.
SYNOPSIS bladeenable slot
DESCRIPTION Use this command to enable all user ports on a blade. All ports within the blade that did not fail the
power-on self-test (POST) are enabled (except for persistently disabled ports). They may come online if
connected to a device, or remain offline if disconnected. Use the bladeEnable command to re-enable
the blade after making configuration changes or running offline diagnostics.
If the switch is connected to a fabric through previously disabled ports, it rejoins the fabric. If this switch
remains the principal switch at the end of the fabric countdown, it assigns itself a domain ID. If another
switch assumes the principal role, the re-enabled switch becomes a subordinate switch and accepts a
domain ID from the principal.
As each port is enabled, the front panel LED changes from a slow-flashing amber to nonflashing green
for online ports or to nonflashing amber for ports that do not initialize. Disconnected ports remain unlit.
NOTES You cannot disable a single blade when the entire chassis is disabled, or when the blade itself is faulted,
powered off, or running diagnostics. Use chassisEnable to enable the ports on an entire chassis.
Persistently disabled ports are not enabled by this command.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operand:
slot
Specifies the slot number to be enabled.
EXAMPLES To display the slot status, enable the user ports in slot 4, and verify the settings:
switch:admin> slotshow
Slot Blade Type ID Status
---------------------------------
1 SW BLADE 2 ENABLED
2 UNKNOWN VACANT
3 UNKNOWN VACANT
4 SW BLADE 2 ENABLED (User Ports Disabled)
5 CP BLADE 1 ENABLED
6 CP BLADE 1 ENABLED
7 SW BLADE 2 ENABLED
8 UNKNOWN VACANT
9 UNKNOWN VACANT
10 UNKNOWN VACANT
switch:admin> bladeenable 4
Blade 4 is being enabled...Done
switch:admin> slotshow
Slot Blade Type ID Status
---------------------------------
1 SW BLADE 2 ENABLED
2 UNKNOWN VACANT