Dell POWEREDGE M1000E - Manual (Page 788)

760 Fabric OS Command Reference
53-1002746-01
portLoginShow
2
portLoginShow
Displays port login status of devices attached to the specified port.
SYNOPSIS portloginshow [slot/]port
DESCRIPTION Use this command to display port login status received from devices attached to the specified port. For
each login, this command displays the following fields:
Type
Type of login can display one of the following:
fd
FDISC, Discover F_Port Service Parameters or Virtual N_Port login.
fe
FLOGI, Fabric Login to Fabric F_Port.
ff
PLOGI, Port Login to specific N_Ports or well-known addresses like Name Server.
PID
The 24-bit Port ID of the attached device.
WorldWideName
The port's world wide name.
credit
The credit for this login as appropriate. This is BB (buffer-to-buffer) credit for Flogs
and EE (end-to-end) credit for PLOGIs.
df_sz
The default frame size for this login.
cos
Class of Services supported. This can be a combination of the following bits:
4
Class 2 is supported.
8
Class 3 is supported.
Further information about each login is displayed after these columns, including the Port ID of the
well-known address or N_Port that was the target of the PLOGI, if applicable.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
This command is not applicable to embedded FCoE ports. Use fcoeLoginShow.
OPERANDS This command has the following operands:
slot
For bladed systems only, specify the slot number of the port to be displayed,
followed by a slash (/).
port
Specify the port for which to display login status information, relative to its slot for
bladed systems. Use switchShow for a list of valid ports.