Dell POWEREDGE M1000E - Manual (Page 632)

604 Fabric OS Command Reference
53-1002746-01
perfMonitorShow
2
perfMonitorShow
Displays end-to-end and interswitch link performance monitors on a port.
SYNOPSIS perfmonitorshow --class monitor_class
[slot/]port [interval]
DESCRIPTION Use this command to display End-to-End (EE) performance monitors on a port. If interval is specified, the
command displays a snapshot of the traffic at the specified interval. If no interval is specified, this
command displays the following information:
Key
The monitor number.
SID
The source Port ID.
DID
The destination Port ID.
Owner_app
The owner application: TELNET, WEB_TOOLS, or API.
Tx_count
The number of FC words transmitted.
Rx_count
The number of FC words received.
Owner_ip_addr
The IP address of the originator that created the EE monitor. Displays the IPv6
address if applications pass the IP address while adding the monitor. If the
monitor is added using performance monitor commands, this field displays N/A.
NOTES ISL Monitors are deprecated as of Fabric OS v7.0.0. Management of filter-based monitors is no longer
supported with this command; it is now provided through the Frame Monitor management interface
(fmMonitor).
This command requires an Advanced Performance Monitoring license.
This command is not supported on virtual FC ports (VE/VEX_Port), EX_Port, M (Mirror) ports and GbE
ports.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operands:
--class monitor_class
Specifies the monitor class as one of the following: EE (end-to-end) or ISL
(interswitch link). These values are case-sensitive.
slot
For bladed systems only, specifies the slot number of the port on which to display
the monitor, followed by a slash (/).
port
Specifies the number of the port on which to display the monitor, relative to its slot
for bladed systems. Use switchShow for a listing of valid ports.