Dell POWEREDGE M1000E - Manual (Page 63)

Fabric OS Command Reference 35
53-1002746-01
ag
2
To disable the ADS policy:
switch:admin> ag --policydisable ads
To enable the WWN load balancing policy:
switch:admin> ag --policyenable wwnloadbalance
To disable the WWN load balancing policy:
switch:admin> ag --policydisable wwnloadbalance
AG port mapping commands
To display current port mappings and port grouping policies:
switch:admin> ag --mapshow
N_Port Configured Static Current Failover Failback PG_ID PG_Name
_F_Ports _F_Ports _F_Ports
-----------------------------------------------------------------
0 4;5;6 None 4;5;6 1 0 2 SecondFabric
1 7;8;9 None 7;8;9 0 1 0 pg0
2 10;11 None 10;11 1 0 2 SecondFabric
3 12;13 None 12;13 0 1 0 pg0
------------------------------------------------------------------
Explanation of fields in --mapshow output:
•
Static F_Ports are part of static F_Port to N_Port mapping.
•
Current F_Ports are the F_Ports that are currently online and mapped to a given N_Port either
because they are mapped to that N_Port or as a result of N_Port failover.
•
Configured F_Ports are the F_Ports that are explicitly mapped to this N_Port (saved in config).
•
Failover and Failback indicate whether or not N_Port policy is enabled (1) or disabled (0).
•
PG_ID is the Port Group ID and PG_Name is the Port Group Name.
To clear all F_Ports mapped to the configured primary N_Port 0:
switch:admin> ag --mapset 0 ""
F_Port to N_Port mapping has been updated successfully
To add F_Ports 4 and 6 to N_Port 0 (observe that Port 0 has no configured F_Ports):
switch:admin> ag --mapset 0 "4;6"
F_Port to N_Port mapping has been updated successfully
To add F_Port 5 to N_Port 2 (observe that N_Port 2 already has mapped F_Ports):
switch:admin> ag --mapadd 2 "5"
To display the new mappings:
switch:admin> ag --mapshow
N_Port Configured Static Current Failover Failback PG_ID PG_Name
_F_Ports _F_Ports F_Ports
-----------------------------------------------------------------