Rockwell Automation 5370-CVIM2 Module - Manual (Page 355)

5 Chapter Chapter 7
Inspection Tools
7–117
— “ Pass Group# ” refers to the “pass” status of a group of tools that
precedes the math tool in the toolset edit panel (see Figure 7.90 on
page 7–111). The group number (1 to 32) is specified by the “#” sign.
This result source returns a logic “1” if all tools in the group pass
during the inspection cycle, and a logic “0” if any one tool in the
group fails.
— “ Fail Group# ” refers to the “fail” status of a group of tools that
precedes the math tool in the toolset edit panel (see Figure 7.90 on
page 7–111). The group number (1 to 32) is specified by the “#” sign.
This result source returns a logic “1” if any one tool in the group fails
during the inspection cycle, and a logic “0” if no tool fails.
— “ Tool 1 through Tool 4 ” refers to the four tools that precede the math
tool in the toolset edit panel (see Figure 7.90 on page 7–111). During an
inspection cycle, tools 1 through 4 are always processed before the
math tool. Their results are stored in system memory, where they are
available to a math tool formula during the same inspection cycle.
NOTE: Results from tools that follow a math tool in the toolset edit
panel are not available to that math tool during the same inspection cycle.
•
The right list contains expanded tool results that pertain to the tool
highlighted in the center list. The list illustrated in Figure 7.92 is empty at
this time. However, when one of the four tool (
Tool 1 through Tool 4 ) is
highlighted in the center (basic results) list, the corresponding expanded
tool results will appear in this list.
The Results panel has two buttons, which are described briefly as follows:
•
Done –– When you pick the button, the system exits back to the
formula entry keyboard and enters the highlighted results selection into
the formula entry field in the keyboard.
•
Cancel –– When you pick the button, the exits back to the
formula entry keyboard, but does not enter any highlighted results
selection into the formula entry field.