Rockwell Automation 5370-CVIM2 Module - Manual (Page 15)

5 Chapter Chapter 1
Hardware Connection and Powerup Check
1–3
4. Install the CVIM2 module in the chassis. Tighten the thumbscrews
alternately until the module is fully seated in the chassis.
Figure 1.1 CVIM2 Module (back view): DC Voltage Selection Switch
DC Voltage selection switch
(shown in internal source position)
Installing the Optional DC Power Supply Cable
If your application requires an external +24VDC power supply, you can use
one of two Allen–Bradley DC power supply cables to connect the external
+24VDC power supply to the Pyramid Integrator chassis power supply. The
power supply must have sufficient capacity to power all of the cameras.
These are the Allen–Bradley DC power supply cables:
•
Catalog No. 5120–CP3 –– for applications not requiring a fan chassis (for
cooling the Pyramid Integrator chassis power supply).
•
Catalog No. 5120–CP2 –– for applications using the eight–slot chassis
and requiring a fan chassis.
Note that each cable has a set of four color–coded leads terminated with
spade lugs.