Rockwell Automation 5370-CVIM2 Module - Manual (Page 18)

Chapter 1
Hardware Connection and Powerup Check
1–6
Connecting the User Interface Cable (2801–NC20A, B, C): VGA
Monitor
Use the following steps to connect the user interface cable when a VGA
monitor is to be used:
1. Locate the user interface cable, Catalog No. 2801–NC20A, B, or C, and
the user interface module, Catalog No. 2801–N26.
NOTE: The two ends of this cable are identical.
2. Connect either end of the cable to the User Interface connector on the
CVIM2 front panel. Tighten the screws.
3. Connect the other end of the cable to the CVIM2 connector on the user
interface module. Tighten the screws.
4. Connect the 15–pin connector on the VGA monitor cable to the VGA
MONITOR connector on the user interface module.
5. Connect the light pen, if used, to the LIGHT PEN socket on the user
interface module.
Connecting the User Interface Cable (2801–NC19A, B, C): N8 Monitor
Use the following steps to connect the user interface cable when an
Allen–Bradley 2801–N8 color monitor is to be used:
1. Locate the user interface cable, Catalog No. 2801–NC19A, B, or C.
2. Connect the 15–pin connector on the cable to the User Interface
connector on the CVIM2 front panel. Tighten the screws.
3. Connect the other end of the cable to the VIDEO INPUT connector on
the rear panel of the N8 color monitor.
4. Connect the light pen, if used, to the LIGHT PEN socket on the N8
monitor front panel.
Connecting the User Interface Cable (2801–NC19A, B, C): Other
RS–170 Monitors
Use the following steps to connect the user interface cable when a monitor
other than the Allen–Bradley 2801–N8 is to be used:
1. Locate the user interface cable, Catalog No. 2801–NC19A, B, or C, and
the user interface box, Catalog No. 2801–N22.
2. Connect the 15–pin connector on the cable to the User Interface
connector on the CVIM2 front panel. Tighten the screws.
3. Connect the other end of the cable to the INPUT connector on the N22
box.
4. Connect the light pen, if used, to the LIGHT PEN socket on the user
interface module.