Rockwell Automation 5370-CVIM2 Module - Manual (Page 23)

5 Chapter Chapter 1
Hardware Connection and Powerup Check
1–11
Figure 1.4 Example: Setting System I/O Port B to Mouse Function
ЗЗ
ЗЗ
ЗЗ
ЗЗ
Pick the button to save the port selections and exit the port setup table,
then perform these steps to check mouse operation:
•
Verify that the mouse operates properly by moving it across a table top.
The mouse pointer should follow the mouse’s movement.
If the mouse pointer does not move at this time, cycle the CVIM2 power
off (for at least five seconds), then on, to enable mouse pointer operation.
•
Verify that the mouse buttons operate by picking one or more of the items
on the main menu, using the left button. In each case, a pull–down menu
should appear.
(Note that the center mouse button can perform some of the functions of
the left button, for example, picking and dragging a panel across the
screen, selecting alternate panel sizes, and operating the scrolling
functions. The right button can alternately position a panel over or under
an overlapping panel.)
For more information about mouse operations, refer to the Screen Pointer
Functions section of Chapter 2, CVIM2 System Configuration: An Overview,
starting on page 2–9.