beautypg.com

Altera Low Latency 40-Gbps Ethernet MAC and PHY MegaCore Function User Manual

Page 23

background image

Parameter

Type

Range

Default Setting

Parameter Description

Enable TX

statistics

Boolean • True

• False

True

If turned on, the IP core includes

built–in TX statistics counters. If

turned off, the IP core is configured

without TX statistics counters. In

any case, the IP core is configured

with TX statistics counter increment

output vectors.

Enable RX

statistics

Boolean • True

• False

True

If turned on, the IP core includes

built–in RX statistics counters. If

turned off, the IP core is configured

without RX statistics counters. In

any case, the IP core is configured

with RX statistics counter increment

output vectors.

Table 2-2: LL 40-100GbE Parameters: 40GBASE-KR4 Tab

Describes the parameters for customizing a 40GBASE-KR4 Low Latency 40-100GbE IP core, on the 40GBASE-

KR4 tab of the LL 40-100GbE parameter editor. The parameters on this tab are available only if the following

conditions hold:
• Your IP core targets an Arria 10 device. You set the target device family for your Quartus II project or in the

Quartus II software before you acess the IP Catalog.

• You select the value of 40GbE for the Protocol speed parameter on the Main tab.

• You turn off the Enable 1588 PTP parameter on the Main tab.

Parameter

Type

Range

Default

Setting

Parameter Description

KR4 General Options

Enable KR4

Boolean • True

• False

False

If this parameter is turned on, the IP core is a

40GBASE-KR4 variation. If this parameter is turned

off, the IP core is not a 40GBASE-KR4 variation, and

the other parameters on this tab are not available.

Enable KR4

Reconfigura‐

tion

Boolean • True

• False

True

If this parameter is turned on, the IP core supports

dynamic analog reconfiguration through a dedicated

reconfiguration interface. If this parameter is turned

off, the IP core cannot support auto-negotiation (AN)

or link training (LT) modes, and the AN and LT

parameters on this tab are not available. This

parameter does not affect FEC availability.

UG-01172

2015.05.04

IP Core Parameters

2-9

Getting Started

Altera Corporation

Send Feedback

This manual is related to the following products: