beautypg.com

Altera Low Latency 40-Gbps Ethernet MAC and PHY MegaCore Function User Manual

Page 164

background image

Word Addr

Bit

R/W

Name

Description

0x4C0

0

RW

AN enable

When set to 1, enables Auto Negotiation function.

The default value is 1. For additional information,

refer to 7.0.12 in Clause 73.8 Management Register

Requirements, of IEEE 802.3ap-2007.

1

RW

AN base pages ctrl

When set to 1, the user base pages are enabled. You

can send any arbitrary data via the user base page

low/high bits. When set to 0, the user base pages

are disabled and the state machine generates the

base pages to send.

2

RW

AN next pages ctrl

When set to 1, the user next pages are enabled. You

can send any arbitrary data via the user next page

low/high bits. When set to 0, the user next pages

are disabled. The state machine generates the null

message to send as next pages.

3

RW

Local device remote

fault

When set to 1, the local device signals Remote

Faults in the Auto Negotiation pages. When set to

0 a fault has not occurred.

4

RW

Force TX nonce

value

When set to 1, forces the TX nonce value to

support some UNH testing modes. When set to 0,

this is normal operation.

5

RW

Override AN

Parameters Enable

When set to 1, overrides the

AN_TECH

,

AN_FEC

, and

AN_PAUSE

parameters and uses the bits in 0xC3

instead. You must reset the Sequencer to

reconfigure and restart into Auto Negotiation

mode. When set to 0, this is normal operation and

is used with 0x4B0 bit 0 and 0x4C3 bits[30:16].

0x4C1

0

RW

Reset AN

When set to 1, resets all the 10GBASE-KR Auto

Negotiation state machines. This bit is self-

clearing.

4

RW

Restart AN TX SM

When set to 1, restarts the 10GBASE-KR TX state

machine. This bit self clears. This bit is active only

when the TX state machine is in the Auto Negotia‐

tion state. For more information, refer to 7.0.9 in

Clause 73.8 Management Register Requirements of

IEEE 802.3ap-2007.

8

RW

AN Next Page

When asserted, new next page info is ready to

send. The data is in the XNP TX registers. When 0,

the TX interface sends null pages. This bit self

clears. Next Page (NP) is encoded in bit D15 of

Link Codeword. For more information, refer to

Clause 73.6.9 and 7.16.15 of Clause 45.2.7.6 of

IEEE 802.3ap-2007.

UG-01172

2015.05.04

10GBASE-KR PHY Register Definitions

B-5

Arria 10 10GBASE-KR Registers

Altera Corporation

Send Feedback

This manual is related to the following products: