Altera IP Compiler for PCI Express - Manual (Page 174)

7–10 Chapter 7: Reset and Clocks
Clocks
IP Compiler for PCI Express User Guide August 2014 Altera Corporation
Refer to Figure 7–7 for this clocking configuration.
Figure 7–7. HardCopy IV GX, Stratix II GX, or Stratix IV GX ×8 with 100 MHz Reference Clock
Notes to Figure 7–7 :
(1) Different device families require different frequency ranges for the calibration and reconfiguration clocks. To
determine the frequency range for your device, refer to one of the following device handbooks: Transceiver
Architecture in Volume II of the Arria II Device Handbook, Transceivers in Volume 2 of the Cyclone IV Device
Handbook, or Transceiver Architecture in Volume 2 of the Stratix IV Device Handbook.
(2) You must provide divide-by-two logic to create a 125 MHz clock source for fixedclk.
refclk clk250_out
Application Clock
clk250_in
pld_clk
core_clk_out
_serdes.v or .vhd
(ALTGX or ALT2GX
Megafunction)
.v or .vhd
_core.v or .vhd
(PCIe MegaCore Function)
rx_cruclk
pll_inclk
cal_blk_clk
reconfig_clk
fixed_clk
refclk
100-MHz
Clock Source
Calibration
Clock Source
Reconfig
Clock Source
1/2
Note (2)
Note (1)