Altera IP Compiler for PCI Express - Manual (Page 169)

Chapter 7: Reset and Clocks 7–5
Clocks
August 2014 Altera Corporation IP Compiler for PCI Express User Guide
Clocks
This section describes clocking for the IP Compiler for PCI Express. It includes the
following sections:
■ Avalon-ST Interface—Hard IP Implementation
■ Avalon-ST Interface—Soft IP Implementation
■ Clocking for a Generic PIPE PHY and the Simulation Testbench
■ Avalon-MM Interface–Hard IP and Soft IP Implementations
Avalon-ST Interface—Hard IP Implementation
When implementing the Arria II GX, Cyclone IV GX, HardCopy IV GX, or
Stratix IV GX PHY in a ×1 or ×4 configuration, the 100 MHz reference clock is
connected directly to the transceiver. core_clk_out is driven by the output of the
transceiver. core_clk_out must be connected back to the pld_clk input clock,
possibly through a clock distribution circuit required by the specific application. The
user application interface is synchronous to the pld_clk input.
Figure 7–4 illustrates this clocking configuration.
Figure 7–4. Arria II GX, Arria II GZ, Cyclone IV GX, HardCopy IV GX, Stratix IV GX ×1, ×4, or ×8 100 MHz Reference Clock
Notes to Figure 7–4 :
(1) Different device families require different frequency ranges for the calibration and reconfiguration clocks. To determine the frequency range for
your device, refer to one of the following device handbooks: Transceiver Architecture in Volume II of the Arria II Device Handbook, Transceivers
in Volume 2 of the Cyclone IV Device Handbook, or Transceiver Architecture in Volume 2 of the Stratix IV Device Handbook.
(2) Refer to Table 4–1 on page 4–5 for information about the core_clk_out frequencies for different device families and variations.
100-MHz
Clock Source
Calibration
Clock Source
Reconfig
Clock Source
Fixed
Clock Source
refclk
Application Clock
pld_clk
Note (1)
tx_clk_out
_serdes.v or .vhd
(ALTGX or ALT2GX
Megafunction)
.v or .vhd
_core.v or .vhd
(PCIe MegaCore Function)
rx_cruclk
pll_inclk
cal_blk_clk
reconfig_clk
fixedclk
core_clk_out (2)
125 MHz - x1,x4,x8
62.5 MHz - x1
250 MHz - x8