MTS Series 793 - Manual (Page 70)

• “DUC” is the type of resource, which is in this instance is a digital universal conditioner.
• “S4” is the slot number in which the resource is installed in the controller chassis.
• “J3A” is the connector label associated with the resource.
Hardware Resource Syntax Models
Syntax*/Comment Example Hardware Type
Syntax: - 494.25 DUC S4-J3A Mezzanine Card
This syntax is used for all of the mezzanine cards
available for MTS I/O carrier boards.
Syntax: connector label Monitor 1 Monitor 2 Anlg
Out (Model 493.42 System
I/O Board only) Models 493.42 and
494.41 System I/O
Board
Syntax: - 493.72 DO T1-J4 Transition Board
Syntax: - n or device n> - Temp Control 1-4-Input Temperature Control
Signal type may be input or output.
Syntax: - Wago DI 1-1 Modbus Device
“Wago” refers to the name of the manufacturer of the
Modbus Device.
*Explanation of resource types:
2SVD = Two-Stage Servovalve
3SVD = Three-Stage Servovalve
DUC = Digital Universal Conditioner
DI = Digital Input
DO = Digital Output
A/D = Analog-to-Digital Converter
D/A = Digital-to-Analog Converter
Other Resource Syntax Models
Comment Syntax Resource Type
Used to create a “virtual channel.” A virtual channel’s
output is not defined by an equation or assigned to <> Virtual Output
hardware, but its output is used by a calculated output
resource that may be used to drive hardware such as a
servovalve.
Used to create a calculated analog input for control
feedback or data acquisition. Calculated input values are <> Calculated Input
70 MTS Series 793 Control Software
Station Builder