MTS Series 793 - Manual (Page 465)

The syntax of the shortcut command line is critical. If you do not use a supported command-line format, the
shortcut will not work.
To view a list of available Station Builder command-line options, enter sysload /H. These options are also
described in the following table.
Note:
If the parameter name contains spaces (for example, test 257.000), the name must be enclosed in
quotation marks (“test 257.000“).
The System Loader application only supports the decorator-based command-line format.
System Loader Command-Line Options .
Example/note Default value Abbreviation
5
Option Description
Used with simulated
load only None /DSP /DSP Launch simulated
DSP
Used with simulated
load only None /Sup /Sup Launch simulated
Supervisor
Used with simulated
load only None /Min /Minimize Minimize launched
applications
None /Sim /Simulation Load simulated
system
/Cont “Control A” None /Cont /Controller Controller name (to
connect to)
None /Un /UnloadSimulation Unload simulated
system
None /NoE /NoExit Sysload open after
load completed
None /H ? or /Help Display the System
Loader command-line
options
Command line example
Sysload /Cont “Control A”
Basic TestWare Shortcuts
For Basic TestWare, you can use a shortcut to automatically specify the following parameters:
• Test name
5
Option names can be abbreviated to anything that is unique.
MTS Series 793 Control Software 465
Command Line Shortcuts