MTS Series 793 - Manual (Page 233)

Master Span Group Errors
If the Master Span Channels list does not include all channels, deleting or renaming a channel that appears
in the Master Span Channels list will disable the Master Span control when the station is opened. A log
message states that Master Span is disabled and that you must edit the Master Span Channels list to enable
the Master Span control.
If all channels appear in the Master Span Channels list, any configuration changes (such as name changes)
appear in the list and the Master Span Control remains enabled.
Channel Tuning Settings
How to Access Channel Tuning Settings
Method 1
Click a control mode and then click the Channel Tuning button to display the settings for that control mode
input.
Method 2
In the Station Setup list, click Channels and then click the Tuning tab.
Adjustments Tab—PIDF Control Modes
This tab’s controls tune selected PIDF control modes for stability and accurate response to commands. The
controls vary with the type of control mode being tuned.
MTS Series 793 Control Software 233
Station Setup