MTS Series 793 - Manual (Page 306)

If the Use as default RSA password check box is selected, the password is stored and the password dialog
will not be displayed when enabling RSA until the password is cleared.
When you try to disable RSA by clicking Enable Remote Setpoint Adjust, a password validation dialog is
displayed. Enter the password and click OK.
If you try to close the Remote Setpoint Adjust window, the same password validation dialog will be displayed.
Clearing the default password
You must clear a saved default password before entering a new password. Clear a saved password before
RSA is enabled by clicking Clear RSA Password on the Password menu in the RSA window.
How to Set Up and Run Tests
The following procedure provides a basic outline of the steps required to run a test. Because of the flexibility
of MTS controllers, your test setup may be different.
1. Start the Station Manager application.
2. Load a test station.
3. If necessary, load a parameter set.
306 MTS Series 793 Control Software
Using Station Manager to Run Tests