MTS Series 793 - Manual (Page 426)

5. In the Absolute End Level box, type the desired end level.
6. In the Time box, type the desired home command ramp time.
7. Repeat steps 3 through 6 for other channels.
How to Use the Home Control
When hydraulics are active, click Home on the Basic TestWare main panel to ramp to the home position.
Configuring Test Counters
Test Counters
Current and Total counters reset to zero and start over when the segment count reaches 4294967296
(2147483648 cycles).
You can use the Test Counters panel to run a test that requires a preset number of cycles or segments. The
Test Counters panel can also be used to run your test for a limited cycle or segment count to help you evaluate
your test settings before running a longer test.
The Test Counters panel on the Basic TestWare window displays the following controls:
Description Item
Specifies the number of cycles (or segments) your test will run. There is a check
box that enables or disables this counter. The check box is greyed out until a cyclic
command type is specified. Preset
The counter only works with cyclic commands. You cannot enter half cycles or an
odd number of segments in the Preset counter box.
Displays the number of cycles (or segments) that passed since you clicked the
Run button. When this counter reaches the Preset count, the test stops. Current
Current cycle count is not automatically reset when you click the Run button on
the Station Controls panel. Click the Current reset button
to reset the current count.
Displays a second counter that can be used to monitor the total number of cycles
or segments. Total
Logging counter events
The following counter actions are written to the message log:
• Resetting the Current or Total counters.
426 MTS Series 793 Control Software
Basic TestWare Application