MTS Series 793 - Manual (Page 144)

Multipurpose TestWare
(MPT) Basic TestWare (BTW) Function Generator Item
Sets the transition time from
stop to run states. Applies in Not used. Not used. Start
procedures where the MPT
application’s Option Editor
window Command Stop
Behavior selection is either
Taper to Mean or Taper to
Level.
Sets the transition time from
run to stop states. Applies to Sets the transition time
for tapered wave Sets the transition time
for tapered wave Stop
procedures where the MPT shapes to go from run
to stop states. shapes to go from run
to stop states.
application’s Option Editor
window Command Stop
Behavior selection is either
Taper to Zero or Taper to
Mean.
Sets the transition time from
run to hold states. Applies to Sets the transition time
for tapered wave Not used. Hold
procedures where the MPT shapes to go from run
to hold states.
application’s Option Editor
window Command Hold
Behavior selection is either
Taper to Zero or Taper to
Mean.
Sets the transition time from
hold to run states. Applies to Sets the transition time
for tapered wave Not used. Resume
procedures where the MPT shapes to go from hold
to run states.
application’s Option Editor
window Command Hold
Behavior selection is either
Taper to Zero or Taper to
Mean.
144 MTS Series 793 Control Software
Station Manager Application