MTS Series 793 - Manual (Page 153)

2. Use one of the following methods to set the Command levels:
Method 1 - Enter the command levels manually
a) From the Control Mode lists, select the control mode for each channel.
b) Type the desired command values in each channel’s Command text box.
Method 2 - Use the current feedback levels
a) From the Control Mode list, select the control mode (or Disabled) for each channel.
b) In the Manual Command control window, select the corresponding command mode or command group
and move the actuator(s) to the desired command level.
c) In the Channel Options window, click Use Current.
The current feedback level is inserted in the command level display.
d) Repeat these steps to define the rest of the command levels for the other commands.
3. Enter a Ramp Time for each command.
This sets the time required for the enabled channels to ramp to the command level.
4. Optional—To rename the text that appears in each rig-command button, type a new name in the name
text box.
5. Optional—Assign a digital-output action to indicate when the desired command level is reached.
a) Use the Event-Action Editor to define the desired action.
Before you assign a digital-output action, make sure that a digital output has been assigned to the
station in the Station Builder application.
b) Select the appropriate digital-output actions in the At Cmd Action and Not At Cmd Action drop-down
lists.
MTS Series 793 Control Software 153
Station Manager Application