MTS Series 793 - Manual (Page 393)

Description Item
Specifies how much the grid’s zero reference on the Y axis shifts from the
center of the display. Offset
Specifies the length of time for a signal trace to cross the scope (also sets
the grid’s X axis scale). You can jog the values up and down with the up-down
control. Trace Time
Trace toolbar controls
available for the Frequency
Plot Mode
Specifies the Y-axis maximum and minimum. Y Maximum/Y Minimum
For FRF (Frequency Response Function) and Coherence modes, the Y
Maximum and Y Minimum controls pertain to the single trace that is calculated
from both signals in the signal pair.
Specifies how frequently the scope acquires data. Sampling Rate
This value is set to the system rate and cannot be changed.
How to Use the Change View Scope Button
Each time you press the Change View button, the scope window progressively removes controls and plot
labels to simplify the display. Pressing the button the fifth time restores the original display.
How to Size the Scope Window
If you make the scope smaller by sizing the window, you should consider enabling the Auto-Sizing control
on the Graph tab of the Scope Setup window.
• When Auto-Sizing is disabled (default), the scope retains all the controls when you size it, which creates
a crowded display when you make the window smaller.
• When Auto-Sizing is enabled, the scope window progressively removes controls when you make the
window smaller.
MTS Series 793 Control Software 393
Scopes and Meters