MTS Series 793 - Manual (Page 167)

Note:
By default, tasks associated with optional hybrid simulation models initially apear in the Outputs list
and can be moved between the Inputs and Outputs lists, but not between boxes (if more than one
box exists).
Calculation Editor
The Calculation Editor is used to define the formulas used to produce a calculated signal. Signals resulting
from these formulas can be output as drive signals, input for use in control modes, and saved as data.
The Calculation Editor requires the Configuration access level.
CAN Bus Editor
About CAN Bus
A controller area network (CAN) bus is a keyed option that allows an MTS controller to use CAN messages
to communicate with CAN devices over a CAN bus network. Depending on the testing application, you can
configure the Series 793 Controller to share information with a CAN device or have it emulate a CAN device.
Note:
The CAN bus option is not available for FlexTest SE Controllers.
CAN network hardware
The CAN bus option requires an MTS-tested, CAN bus controller card that is installed on a processor board.
This card includes two CAN bus ports that are independently configured and assigned to stations.
MTS Series 793 Control Software 167
Station Manager Application